Common problems and solutions during pipe extrusion

2022/5/14

In the process of plastic pipe production line, because the operator is not skilled in the process a

How to solve the problem of PPR pipe extruder in use

2022/5/14

1. There are focal marks on the surface of the tube. The possible reasons are that the temperature of the body or the head is too high; the head and the filter are not cleaned; there are impurities in

The development trend of PE pipe high-speed production line

2022/5/14

The reform of the PE pipe high-speed production line industry is urgent, but no matter how the marke

Common faults and solutions of rubber extruders

2022/5/14

1. Abnormal noise
1. If it occurs in the reducer, it may be caused by bearing damage or poor lubrication, or it may be caused by gear wear, improper installation and adjustment, or poor meshing. I

Common problems and solutions of PE pipe extrusion production line

2022/5/14

In the process of plastic pipe production line, because the operators are not skilled in the process

The main points of process operation in the production of polyethylene gas pipes

2022/5/14

The gas pipes commonly used in modern society are generally polyethylene gas pipes, which are generally high-density polyethylene gas pipes, and are mainly used for plastic pipes for transporting coal

What are the problems of section deformation of the plastic pipe equipment produced by the extruder?

2022/5/14

The modern plastic pipe industry is mainly produced by extrusion molding. The plastic pipe is usuall

Plastic pipe extrusion die structure

2022/5/14

The extrusion molding head is an important component in the extrusion molding production line. Its function is to further compact and plasticize the plasticized melt. After being split, it enters the